|
|
CleanStream HEPA Filter for Genie and Black & Decker Wet Dry Vacuums
|
Item Number: FCH000003
|
Replacement Filter for:
- Genie wet dry vacuums (series PB, PH, PSH, 2000, 3000, and 4000)
- Black & Decker Utility Vacuums (UV800B and UV1000B)
Filter Dimensions
- Height: 7 inches
- Diameter: 7 1/2 inches
- Inner Diameter: 5 3/4 inches
Characteristics
- HEPA: High Efficiency Particulate Air
- Filter easily cleaned by tapping-dirt falls away
Wet Dry Filter Installation Instructions
- Remove old filter and clean sealing surface on lid.
- Carefully slide opening of filter over cage.
- Push bottom of filter firmly until gasket seats against ribs on vac lid. The filter fits tightly on vac to provide a good seal.
- Do not collect oily or hazardous materials.
CleanStream Filter 09067 for Genie Wet Dry Vacuums
 |
Original Genie Filter
 |
|
CAUTION: FOR LIQUID PICK-UP DO NOT FILL ABOVE INLET OR SPILLAGE WILL OCCUR. Your CleanStream filter repels liquids and when installed prevents your vacs float mechanism from automatically shutting off airflow. Airflow will cease when your filter is completely submerged in liquid, but spillage will occur if the water level reaches the vac drums inlet before airflow stops. The liquid level at which airflow will cease will be higher than the normal automatic shut-off level. Your vacs float mechanism resumes operation after removing the filter. Your filter should be dried completely after liquid pick-up to avoid mildew growth.
IMPORTANT: AVOID TOUCHING FILTER MEDIA WITH ABRASIVE MATERIALS OR USING A BRUSH TO CLEAN BETWEEN PLEATS. THIS WILL PERMANENTLY DAMAGE FILTER CAUSING DUST TO BYPASS FILTER.
Wet/Dry Filter Cleaning Instructions
 Clean installed filters by gently tapping outside of dust drum. Thorough cleaning requires removal of filter. In a well-ventilated area, tap metal end cap against a hard surface to remove debris. Wash remaining debris from pleats with running water. Completely dry filter after washing. |
|
|
|
|